Thru-Hole AndyMark Robits to Threaded goBILDA® Pattern Adaptor

Looking to blend build systems? Pattern adaptors are here to help! This particular adaptor can fasten to AndyMark’s Robits Tube using 10-32 (or M5) hardware, with the remaining holes being four M4 threaded holes on the goBILDA® 16mm square pattern.

To maximize versatility, the Robits pattern options are plentiful: you’ll find them down the center of the adaptor in order to align the part down the center of the ½”-spaced holes, as well as flanking each side of the center so that it can be aligned with the tube itself—or even span the gap between two tubes!

Additionally, this adaptor’s strategically tuned height allows a pair of this adaptor sandwiching a 1” tube to create an overall assembly width of 48mm: the same width as goBILDA® 1120 Series U-Channel, which leaves you with easier building from there on out!